Page 1700 - Foton Workshop Manual - Tunland (AT)

34-40 AXLE AND PROPELLER SHAFT - FRONT DRIVING GEAR

(n) Further tighten the nut.
Torque (increase): 5N·m

Torque (max.): 245N·m

(o) Measure the driving gear startup torque with
a torque wrench again.
Startup torque: 0.49～0.69N·m

NOTICE

If the startup torque is still below the limit, repeat
Steps (15)-(16) until it reaches the required range.
If the nut torque exceeds the maximum value
while the driving gear startup torque is still below
the limit, replace a new driving gear bearing
sleeve. (Refer to "Chapter 34. Axle &
transmission shaft - front driving gear,
overhaul")
34
(p) Lock the nut.

Page 1700