Page 122 - Condition Monitor User Manual

Viewing Measurement Data

The ribbon will display the control for manipulating the view:

• In the ‘Measurement Data’ section of the ribbon select the Summary Number to
analyze.

The measurement list will all measurements; raw data is not needed to do a statistical
analysis.

Once the Summary Number selection is made the graph is automatically populated with
all measurements that are flagged as ‘Trend’ in the measurement list; if no measurements
are set for ‘Trend’, then no data will be displayed. The graph will show the
maximum/minimum span of the Summary Number over the entire trend as well as the
average value and the last value.
The ‘Graph Operations’ section of the ribbon contains additional functions that may be
useful:
• Press the ‘Clipboard’ button to copy the current graph to the clipboard; it can then
be pasted into other documents.
• Press the ‘Maximize’ button to show the current graph in full-screen mode. Press
the Esc key on the keyboard to close the full-screen graph.
• Check or clear the ‘Hide Table’ checkbox to either show or hide the statistics table
underneath the graph.

9.1.9. Settings View
The Settings View is used to configure the Alerts, units and the frequency cutoffs. To
open the Settings View, select the ‘Settings’ tab in the ribbon.

Figure 9-18 Settings View

116
www.irispower.com