Page 243 - Workshop Manual - Aumark (BJ1051)

04-99
Diagnosis-illlumination

Diagnosis-Illumination

Illumination
Notes
1. Power off.
(a) Before you remove or install any electrical device or when tools or equipment are accessible
to bare electrical pins, be sure to disconnect battery negative cable first in order to prevent
personal injury or vehicle damage.
Tip:
Please do not leave your car key in your vehicle before battery negative cable is disconnected so as
to avoid locking doors.
(b) Ignition switch must be turned OFF unless specifically stated otherwise.
2. Disconnecting battery negative cable will clear day odometer and clock on combination 04
meter.
Tip:
Total odometer will not be cleared.
3. Disconnecting battery negative cable will cause audio system to lose saved settings.
Tip:
After battery negative cable is reconnected, you need to reset audio system (refer to “Operation
Manual of the Audio System” in Chinese and English).
4. Replacing bulbs with care
(a) If oil stains are left on surface of a halogen bulb, the bulb’s life will also be shortened and it
will be burned out due to overheat.
(b) Great care must be taken when handling a halogen bulb because high pressure exists inside
it. Dropping, hitting or damaging it may result in explosion and fracture.
(c) When replacing a halogen bulb, be sure to wear safety goggles.
(d) When taking a bulb, hold its lamp holder only and avoid contact with glass.
(e) Keep a bulb ready for immediate replacement because the bulb’s reflector will absorb dust
and water vapor if the used bulb has been removed from your vehicle for a prolonged time
during replacement.
(f) Replace with a bulb of equal power.
(g) After bulb replacement is completed, reinstall lamp holder firmly. If water vapor near lamp
holder enters the reflector, the reflector may become blurred.

Page 243