Page 24 - 27771

Cleaning, Disinfection and Sterilization Cleaning, Disinfection and Sterilization

7.2 Disinfection and Sterilization Procedure for Lip Clip, Operation Operating mode Warning
Connection Hook and Fork
• Pulp and dentine • Do not allow remnants to dry
Foreword remnants must be on. Clean no later than 2
removed from the hours. For visible impurities
For hygiene and sanitary safety purposes, the lip clip, the connection accessories that are observed on
hook and the fork must be cleaned, disinfected and sterilized before immediately. instruments, a pre- cleaning
each usage to prevent any cross-contamination between patients. This • After using the is recommended by brushing
concerns the first use as well as the subsequent uses. accessories on the them manually with soft
General recommendations patient, place them material. Only use clean, soft
• Use only a disinfecting solution which is approved for its efficacy directly into a dish brushes to manually remove
(VAH/DGHM-listing, CE marking, FDA approval) and in accordance filled with a suitable contamination and remnants,
cleaning and
or a clean, soft cloth or wipe
with the DFU of the disinfecting solution manufacturer. For all metal disinfection solution that is only used for this
instruments, it is recommended to use anticorrosion disinfecting (e.g. CIDEZYME , purpose. Do not use metal
®
and cleaning agents; ® brushes or wire wool. Check
• For your own safety, please wear personal protective equipment ENZOL Enzymatic that no visible contamination
Detergent Solutions,
(gloves, glasses, mask). Johnson & Johnson or remnants remain, and
• The user is responsible for the sterility of the product for the first Medical, 0.8% for repeat the pre-cleaning
cycle and each further usage as well as for the usage of damaged 2 Pre-Disinfection between 1 minute process if necessary.
or dirty instruments where applicable after sterility. and 2 hours) for • Make sure that the products
• Limitations and restrictions on reprocessing: cleaning, pre- • are fully immersed.
The disinfectant solution
the appearance of defects such as cracks, deformations (bent, disinfection and should be aldehyde free (to
twisted), corrosion, loss of colour coding or marking, are indications interim storage. avoid blood impurities
that the devices are not able to fulfil the intended use with the • Wash the fixation), suitable for
required safety level. accessories under disinfecting the accessories,
flowing sterile,
• Use only clean water in all cleaning and rinsing steps. deionized water or in and compatible with the
a disinfection solution • accessories.
Disinfectant used for pre-
Step-by-step procedure at least three times treatment is only for personal
for a minute each
time, in order to protection and does not
Operation Operating mode Warning remove all visible obviate the need for
disinfection once cleaning
traces of
• Disassemble the has been completed.
1 Disassembling contamination and
device. remnants. Pre-treatment should never
be omitted.
• Abundant rinsing • Use clean water.
(at least 1 min). • If a pre-disinfectant solution
contains a corrosion
3 Rinsing
inhibitor, it is recommended
to rinse the instruments just
before the cleaning.

24/222 BMLPXEMDFUPRT / Rev.12 / 10-2018 A1030 000 000 00 1 BMLPXEMDFUPRT / Rev.12 / 10-2018 25/222 #