Page 56 - scales manual v1014 web

OHAUS

OHAUS ADVENTURER

1. Press and Hold 0/T until “Cal” is displayed
2. –C- is displayed, followed by calibration mass
3. Load scale with calibration mass and press 0/T

OHAUS CD-11

1. Move calibration jumper onto pins
2. Press and hold ZERO/MENU until “MENU” is displayed
3. Release button, “CAL” will be displayed
4. Press ZERO/MENU, -C- is displayed
5. Apply specified weight and press ZERO/MENU
6. Remove calibration jumper

OHAUS CS

1. Press and hold Cal/UNIT key until calibration weight flashes
2. Press ON/OFF/ZERO key until “CAL 0” is displayed
3. Place Calibration weight on pan, scale will read “CAL F” then return to active weighing

OHAUS CW-11

1. Press and Hold G/N/T/Menu button(Cal is displayed)
2. Press G/N/T/Menu, “Span Y” is displayed
3. Press G/N/T/Menu, “-C-“ is displayed
4. Calibration weight is displayed
5. Place Cal weight and press G/N/T/Menu

OHAUS ES

1. Press and hold Cal/Units until Cal weight flashes
2. Press ON/OFF/ZERO, “CAL 0” is displayed for 2 seconds
3. Place calibration weight on pan
4. “CAL F” will be displayed then return to active weighing

OHAUS EXPLORER

1. Press Setup Button, “CAL” is displayed
2. Press ENTER button, “CAL TYPE” is displayed
3. Press ENTER button, “CAL TYPE inCAL” is displayed
4. Press  button until SPAN is displayed
5. Press ENTER
6. Display will then prompt for weight, place weight on pan, then press ENTER
7. CAL SET is displayed then it returns to weigh mode

© 2014 ScaleResource.com Page 56