Page 852 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 852

3.20                                                                                                                                              3-65








                                                       7                                                                                                         2006 Softail: Engine
                                                  5                                                       Aligning holes, place breather baffle (5), cover gas- ket (3) and breather cover (2) on top of breather baf- Slide two fasteners (1) through stackup to keep

                                        3                                                          Figure 3-89. Breather Assembly Place breather baffle gasket (7) on a clean flat surface.   assembly together until time of installation.  See  BREATHER ASSEMBLY under 3.17 TOP END OVER-
                                   2                                                                                                   Continue with vehicle assembly as directed.
                              1                                                              Breather baffle gasket Rocker arm support plate  INSTALLATION OVERVIEW
                                                                                Fasteners (2)  Breather cover  Cover gasket  Umbrella valve  Breather baffle  Filter element  fle gasket.  Install breather assembly.



                                                          6         8                                                            HAUL: ASSEMBLY.
                        s0596x3x                 4                              1.  2.  3.  4.  5.  6.  7.  8.  a.   b.

                                                                                                        3.                          1.  2.

                                                                               Wear
                                         Remove two fasteners (1) from the breather assembly cover (2) and remove breather Remove the breather cover and cover gasket (3). Dis- card gasket. Remove breather baffle (5) and breather baffle gasket (7). Discard gasket. Pull filter element (6) from bore on underside of breather baffle. Pull umbrella valve (4) from hole at top of breather baffle. Discard both  1WARNING 1WARNING Compressed air can pierce the skin and flying debris from safety glasses when working with compressed air. Never use your hand to check for air leaks or to determine air Clean all parts in a non-volatile cleaning solution or sol- vent. Blow parts dry wit



               Y
               BREATHER ASSEMBL




                       REMOVAL OVERVIEW See beginning of 3.16 TOP END OVERHAUL: DISASSEM- BLY to remove breather assembly.  DISASSEMBLY  Figure 3-89.  assembly from rocker arm support plate (8).  filter element and umbrella valve. CLEANING AND INSPECTION  compressed air could cause serious eye injury.   0.005 inch (0.13 mm).  through hole and resides on bottom side of baffle.













          HOME                           See   1.  2.                                flow rates. (00061a)  1.  2.  3.  (0.13 mm).  ASSEMBLY  1.  2.  stem.








        3
   847   848   849   850   851   852   853   854   855   856   857