Page 556 - Med Plaza and Cancer Center

Finish Installation

Source Equipment Wiring

Holes provided for
entrance of remote wiring

Route wires behind Sample label
metal brace (provided)

Slide label(s) into slits
in front panel overlay

Figure 23: Multi-Signal Front Panel Labeling

Figure 21: Source Equipment Wire Routing Field Wiring Cable Shield Grounding
All field wiring cable shields must be
grounded inside alarm panel back box. A
grounding screw is provided in upper right
Signal 3 corner of alarm back box as shown in
Figure 24. Shields from several cables
Signal 4 Signal 2
may be wrapped together and crimped into
Signal 5 Signal 1
one ring lug (by others) .

Cable shield
grounding screw
(crimp lug not provided)
Multi-Signal Module

Figure 22: Source Signal Wiring Termination

Figure 24: Field Wiring Cable Shield Grounding

CAUTION:
Keep shield wires to ground screw as short as
possible so they can not touch front panel circuit
boards when front panel is closed

31
Part No. 6-847684-00 Rev. E00