Page 561 - Med Plaza and Cancer Center
P. 561
Operation
Set-Up Procedure N N DD FF (network data format)
Defines data word length transmitted to
Digital Display Module building automation system. User
choices are 88 (bits) or 11 66 (bits). Factory
setting is 88.
6. Press and release TEST button.
HIGH indicator will illuminate and KK ,, P P DD FF (pressure data format)
will be displayed. After two seconds
Defines data word length transmitted to
current high alarm setting will be dis-
a slave alarm panel. User choices are
played. Select desired high alarm set-
8 8 (bits) or 11 66 (bits). Factory setting is 88.
ting by pressing either or but-
tons. High alarm setting ranges are: The second advanced level, SS EE TT 33, is
used to adjust other miscellaneous
0 0 to 11 33 88 00 (11 77 22 55*) (kPa)
parameters as listed below:
0 0 to 22 00 00 (22 55 00*) (psig)
0 0 to 33 22 or NN OO NN EE (in Hg) S S EE RR UU (gas service identification)
0 0 to 88 00 00 or NN OO NN EE (mm Hg) Used to set digital display module’s gas
*N2 and instrument air only, DDM firmware 1.0.6 or later service identification for communication
with a digital sensor.
7. Press and release TEST button to
User choices are:
save changes. DD OO NN EE will be dis-
played for two seconds. Digital dis- 0 0 22 (oxygen)
play module will return to monitoring N N 22 00 (nitrous oxide)
mode. A A ,, RR (medical air)
U U AA (( (vacuum)
N N 22 (nitrogen)
Digital Display Module (Advanced)
L L AA ,, RR (lab air)
L L UU AA (( (lab vacuum)
Two additional levels of “advanced” set-up A A RR 99 NN
features are available. (argon) (Firmware 1.0.6 or later)
I I AA ,, RR (instrument air)
The first advanced level, SS EE TT 22 , is used to U U AA 99 DD (WAGD)
adjust basic communication related ( ( 00 22
parameters. The parameters adjustable (carbon dioxide)
( ( -- 00 22 (CO2/O2)
within SS EE TT 22 are listed below: 0 0 22 -- (( (O2/CO2)
A A DD DD RR (network address) K K EE 00 22 (He/O2)
0 0 22 KK EE (O2/He)
A network address uniquely identifies K K EE
each digital display module to a N N OO NN EE (Helium)
personal computer or Johnson Controls (none)
Metasys® system. Address range is 00 NOTE:
to 22 55 55. Factory setting is 00. Set to NN OO NN EE if using analog sensors.
B B AA UU DD (baud rate)
O O FF FF SS (display offset)
Used to set communication speed.
Used to adjust digital module’s display.
User choices are 44 88 00 00 or 99 66 00 00.
User choices are 00, 11, 22, -- 11,or -- 22 .
Factory setting is 44 88 00 00.
Factory setting is 00.
36
Part No. 6-847684-00 Rev. E00
