Page 562 - Med Plaza and Cancer Center
P. 562
Operation
Set-Up Procedure 4. Press and release TEST button. NN DD FF
will be displayed for one second and
then current network data format.
Digital Display Module (Advanced)
Select desired data format by pressing
or buttons.
R R EE PP TT (audible alarm repeat) 5. Press and release TEST button. PP DD FF
Used to set time interval for will be displayed for one second and
reactivation of audible alarm after then current pressure data format.
Select desired data format by pressing
alarm MUTE button has been
or buttons.
pressed. User choices are OO FF FF, 11, 55,
6. Press and release TEST button to save
1 1 55, 33 00 (minutes), 11 HH RR, 88 HH RR, 11 22 HH RR or
changes. DD OO NN EE will be displayed for
2 2 44 HH RR (hour). Factory setting is OO FF FF. two seconds. Digital display module
When set to OO FF FF, audible alarm will will return to monitoring mode.
not reactivate after an active alarm
has been silenced. Any new alarm will Changing Miscellaneous Parameters - (SS EE TT 33):
reactivate audible alarm. 1. Press and HOLD SETUP button for
I I NN TT SS (display intensity) FOUR seconds until SS EE TT 33 is displayed.
2. Press and release TEST button on front
Used to adjust digital module’s display
of alarm panel. SS EE RR UU will be displayed
brightness. Factory setting is for one second and then current gas
maximum intensity. service identification. Select desired
NOTE: gas service by pressing or
If module is idle for more than one minute during buttons.
set-up procedure, module will chirp three times, 3. Press and release TEST button. OO FF FF SS
return to monitor mode and will default to previous
settings. No changes to settings will be saved. will be displayed for one second and
then current display offset. Select
Set-up must be completed and module must dis- offset by pressing or buttons.
play DD OO NN EE in order for changes to be saved. 4. Press and release TEST button. RR EE PP TT
will be displayed for one second and
Changing Communication Parameters - then current audible alarm repeat time.
(SS EE TT 22): Select desired repeat time by pressing
or buttons.
1. Press and HOLD SETUP button for
5. Press and release TEST button. II NN TT SS
TWO seconds until SS EE TT 22 is displayed.
2. Press and release TEST button on will be displayed. Select desired
display brightness by pressing or
front of alarm panel. AA DD DD RR will be buttons. Each push will change
displayed for one second and then
brightness of display. Audible alarm will
current network address. Select
desired address by pressing or chirp one time with each push and two
buttons. Each module must have a times when limit reached.
unique address. 6. Press and release TEST button to save
changes. DD OO NN EE will be displayed for
3. Press and release TEST button.
two seconds. Digital display module
B B AA UU DD will be displayed for one second will return to monitoring mode.
and then current baud rate. Select
desired baud rate by pressing or
buttons.
37
Part No. 6-847684-00 Rev. E00
