Page 216 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 10 Initial Startup

Startup Procedure

Foaming Components Setup

1) Open Triple Foam water valves completely (located in the Carriage). Force on TF CHEM and
TF WTR/AIR. Set chemical pumps to supplier’s recommendations. Increase Tri-Foam air
pressure (in passenger side pod) to about 10PSI. Continue to increase until air blows past
the chemical and then reduce air slightly. This can be done by sound. Adjust the 3 Tri-Foam
gate valves inside the exit water manifold cover to achieve the desired “wetness”. NOTE:
Yellow typically requires more chemical. Tilt Tri-Foam Pods to get the best spray pattern
on average vehicles. Next turn soap back on and adjust spray angle for soap pods. Reset all
forces.

Pulsatron Pump Style Shown

Tri-Foam
Adjustment Screw
Tri-Foam Tri-Foam Pod
Gate Valves

Single Foam Pod

Setting Cylinder Flow Controls
1) Set cylinder flow controls as stated below.
• Exit Arm Side: Green Ring on flow control
• Entrance Pivot Side: Blue Ring
• Top Wheel: Open 1/4 Turn (to green ring)
Ring Color Turns open
Green 1
Orange 2
Blue 3
Silver 4
Red 5 (full)

Note: Never lower top wheel when entrance water manifold cover is open.

2) Close all covers (entrance and exit water covers and both pod covers).

10-12 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL220