Page 213 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 10 Initial Startup

Startup Procedure

Re-Setting the Cylinder Reed Switches
After de-stroking a cylinder, the Read Swich will need to be re-set. Follow the instructions below to do so. All cylinders
have one Reed Switch except the passenger side Entrance Arm. It has 2.

Reed Switch Single Switch Cylinder Dual Switch Cylinder (Passenger Side, Entrance)

1) On the wheel to be set, make sure it is in its “open” position. Depending on the wheel, this may be extended
or retracted.

Arms Closed Arms Open
2) Once the wheel is in the proper position, loosen the clamp on the appropriate cylinder and slide it until the
Read Switch is illuminated.
3) Notice the location when the light first comes on and continue to slide it in that direction until the light turns
back off.
4) Secure the clamp in the center of the “illumination” area.

1MANUL220 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 10-9