Page 37 - TopWinder®

®
®
TopWinder

Installation

Loading the ShineMitt™ onto the Hub Assembly

1) On the driver side of the Hub Assembly remove the Hub Cap Fasteners and slide the Hub Cap
all the way over to the Arm Assembly.
Hub Cap Driver Side
Arm Assembly Step 2:
Remove the plastic Clamps
from the End Plate.

Clamp (4)

Hub Assembly

End Plate
Step 1:
Remove Hub Cap Fasteners
and slide Hub toward Arm.

2) Remove the four plastic Clamps that secure the LED Wires against the End Plate.

3) Remove the End Plate Fasteners. Gently pull the End Plate away from the Hub Assembly and
disconnect the four (4) LED Wires from the Wire Harness connectors.

Step 3: Step 4:
Remove the End Plate Fasteners. Gently Pull the LED Wires out of the End

pull the End Plate away from the Hub and Plate and slide the End Plate
disconnect the LED connections. toward the Arm.

4) Pull the Wire Harness Wires out of the End Plate holes and slide the End Plate toward the Arm
Assembly.

5) Locate the ShineMitt™ there should be a total of 112 pieces.

Clip
ShineMitt™ 19” 45 Degree Short Lead

1MANUL755 Belanger, Inc.® * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 33