Page 20 - Gyro Wrap™ Signature ® Series
P. 20
GYRO WRAP™ Signature ® Series
Installation
Attaching the Arms and Cylinders
4) Push the bottom bearing all the way up until it stops and tighten the two set screws. Do not tighten the
two set screws on the top bearing.
5) Using a forklift, secure the driver side Arm Assembly to the forks using two C-Clamps.
Note: Be sure to use protective material on the arm assembly so that you do not scratch the
powder coating.
6) Secure the driver side Arm Assembly to the Head Beam Assembly as shown below. Tighten the two set
screws on the top bearing after all of the bearing fasteners have been tightened down.
7) Repeat the above steps on the passenger side Arm Assembly.
8) Remove the driver side and passenger side Cylinder/Oil Reservoir Assemblies from the accessory box
as shown below. Use the images to distinguish between the two assemblies.
Passenger Side
Assembly
Driver Side
Assembly
16 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL248