Page 31 - H2AIR® Arch
P. 31

®
               H2AIR  ARCH


               Utilities

               Electrical Connection: Main Power to DryLite™ Dryer Motors
                  1)  Run the main power lines for the Motors out to the DryLite™ Air Cannon™ Dryer Assemblies and
                      make the wire connections to the motor wires inside the Electrical Boxes.

                                                  CAUTION

                      It is recommended that a licensed electrician is contracted to perform all electrical installations.
                                                                                                 Dryer Motor
                               Dryer Motor                                                       Electrical Box
                              Electrical Box





























                       Note:  Make  sure  electrical  box  penetrations  are  made  with  an  approved  method  for  wet
                             conditions. A proper cord grip should be used and installed correctly and a drip loop on
                             incoming cables is recommended to avoid any water intrusion.

                       Note: The electrical connections are made with either heat shrink butt splices or dielectric grease

                             wire nuts.


                  2)  When everything is wired properly, close and seal the Electrical Boxes; be cautious to not crimp
                      down on any of the wires.
                  3)  Test to see if all the dryers are functioning properly by using the Controller to turn on each of the
                      dryers.

















                 1MANUL958         Belanger®, Inc. *PO BOX 5470 *Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681     27
   26   27   28   29   30   31   32   33   34   35   36