Page 84 - FreeStyler® Maintenance Manual
P. 84

®
            MAINTENANCE


            Chapter 3 General Repairs


            Changing a Roller or Drive Shaft


               Non-Driven (Idler) Rollers
               7)  If you are changing the roller, reassemble the roller assembly with the new roller and put it
                   back on the machine.
                 If you are changing the bearing, take the roller spacer off the old bearing, and attach it to the
                   new bearing and then reassemble the roller assembly completely.
                                                  Spacer




                                         Bolt
                                                                              Bearing


               Note:  Be sure to follow all of the installation procedures as described in the General repairs section of
                       this chapter.

               8)  Make sure that when you reattach the encoder shaft into the bearing to put the shaft spacer
                   back onto the shaft. Apply red Loctite® 271 to the flange bolt that holds the shaft and tighten
                   down to the proper tightening torque shown on the chart on page 3-1 of this manual.
                                                                                    Encoder Gear



                                          Spacer

                                                                        Encoder Gear Shaft

                                 Bolt
                                                                      Bearing


               9)  Attach the non-driven roller assembly to the machine.  Then evenly lower the machine back
                   onto the rail by alternately loosening both of the jack bolts until no part of the bolts are sticking
                   below the safety bracket, then tighten the jam nuts down.





                          Non-Driven
                          (Idler) Roller (2)                                   Safety Bracket (4)
                                                                               Jack Bolt (4)



                                                                               Jam Nut (4)

                               Rail (2)



             3-20            Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681                 1MANUL222
   79   80   81   82   83   84   85   86   87   88   89