Page 91 - FreeStyler® Maintenance Manual
P. 91

®
                       MAINTENANCE


                       Chapter 3 General Repairs


                       Replacing an Arm Rotation Bearing

                          1)  Place a block or some type of spacer underneath the bottom of the hub at the wheel.

                          Note:  The easiest way to do this would be measure the height with a tape measure and cut something
                                 to the right size to fit snug underneath the hub or use a jack.

                                Also you should have somebody stabilize the arm as you perform the repair.
                          2)  Once these steps have been met:
                                Loosen the bearing bolts and set screws, and slide the old bearing off the machine. See
                                 the image below.
                                                             Shaft Collar
                                                             Upper Bearings Only











                                                                                Bearings have two set-screws each



                          Note:  If it is an upper bearing, you will need to remove the shaft collar from the top of the shaft as
                                 well. See the image above.

                          3)  Slide  the  new  bearing  back  onto  the  shaft;  tighten  the  bolts  back  into  the  bearing  mount
                              attachment. See the image above in Step 2.
                                Then tighten the set screws,
                                If it is an upper bearing put the aluminum shaft collar back onto the top of the shaft and
                                 tighten it.


                       Replacing a Pivot Shaft Assembly
                          1)  Follow the steps to replace a bent shaft explained above.

                          2)  Loosen the set screw that holds the wheel nozzles in place and unscrew the nozzle housing
                              (white plastic piece) from the machine. See the image below.





                                     Air Line

                                          Elbow Fitting

                                      Nozzle Housing
                                                              Set Screw
                                                    Nozzle (2)   Filler Strip
                                                               Cord Grip

                        1MANUL222               Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681                  3-27
   86   87   88   89   90   91   92   93   94   95   96